Assembling the Microbee MultiROM

So I have finally got a design for a “MultiROM” ROM changer suitable for use with the PC 85, capable of fitting in a standard case in the ROM H position at IC 22.

https://github.com/cheshirenoir/BeeMultiRom

Assembling these is a little non standard so here’s a guide.

You will need:

If your pins are in a socket or strip, use a sharp set of cutters and cut them out of their housing. These should drop right into the PCB in the wide holes. Fill all the wide holes.

Here I am breaking up sockets. I have stopped using this type so I have plenty to spare.

Once you have filled all the wide holes, insert the spare socket into the top of the turned pins. This will aid in soldering.

Ignore the “extra” pin.

Flip the board over and solder in all the pins. Remove the socket once complete. If your socket isn’t as long as your pins, you’ll need to add more pins and move the socket.

Once all the pins are soldered in, cut the thin part of the legs off them. Yes, it feels criminal, but we’re using these as sockets, not as pins.

Next we solder in the header strip in the next row of holes, poking down. If you’re using the same strip as me, the default length will be fine. If you’re using something else, be careful with your lengths. If you make them too long, you won’t have enough room to close the lid. Too short and you might hit the socket.

The rest of the components can be added in now. Don’t forget the resistor pack has a polarity. Make sure the dot matches the square pin.

Note the square pin for the Resistor array.

Add your 27C2001 ROM in after programming in images. You have 16 x 16k ROM images in there. Or 32 x 8k ROM images. Or a mix, as long as you keep everything aligned to 16k boundaries. (If you have 8k ROMs, they can be accessed by either PAK4 or PAK12 commands. If you have 16k ROMs, they can be accessed by PAK4)

Finally the bit I have to leave a bit open. This is the hex encoder. There are SO many options here. I’ve tried this and this. Neither is perfect. The first feels flimsy. The second only supports 10 positions, and is too big to actually fit in the case. Either way, you connect the “common” pin of your encoder to pin 1 and 2-5 to the remaining pins. You could probably even rig up a 4 way DIP switch by wiring all the pins on one side together then to pin 1 on the connector. Then connect the other side to pins 2-5.

I am currently using the second encoder option.

Published by ilike8bits

I collect old computers and consoles

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

%d bloggers like this: